Filter
Top Products
MR-2017/2020 © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND ASSEMBLY
4 - 14
(3) Take off the read motor drive section.
( P. 4-19 "[D] Read motor drive section")
(4) Remove 1 bushing, 1 E-ring and 1 pulley
from the rear side of the post-reading roller
shaft. Loosen 2 setscrews and take off 1
flange. Take off 1 bearing.
Fig. 4-40
(5) Remove 1 clip, timing belt, 1 pulley, 1pin, 1
E-ring and 1 bushing from the front side of
the post-reading roller shaft.
Fig. 4-41
(6) Open the RADF. Remove 4 screws, take off
2 holders and platen guide.
Fig. 4-42
BearingFlange
Bushing
E-ring
Pulley
Clip
Pin
Bushing
E-ring
Pulley
Timing belt
Holder
Platen guide
Holder