Filter
Top Products
© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved MR-2017/2020
ADJUSTMENT
5 - 1
5
5. ADJUSTMENT
5.1 Adjustment of Position
Perform this adjustment when the ADF is not installed in the correct position.
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the ADF. (See the Service Handbook of the applicable equipment.)
[A] Checking
(1) Open the ADF and install 2 positioning pins
(the positioning pins are installed to the back
side of the hinge which is on the left side of
the ADF).
Fig. 5-1
(2) Remove the platen sheet.
Fig. 5-2