Filter
Top Products
MR-2017/2020 © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND ASSEMBLY
4 - 18
[C] Read motor (M2)
(1) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(2) Disconnect 1 connector, and then remove 1
spring. (Spring: Outside diameter of coil –
ø10.2 mm, active coils – 12.5)
Fig. 4-51
(3) Remove 3 screws, and then take off the read
motor with its bracket.
Note: Note:
When the unit is being assembled, tempo-
rarily tighten the screws removed at step (3),
and then attach the spring removed at step
(2). Then fully tighten these screws.
Fig. 4-52
(4) Remove 2 screws and take off the read
motor.
Fig. 4-53
Connector
Spring
Read motor
Read motor