Filter
Top Products
MR-2017/2020 © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND ASSEMBLY
4 - 12
[H] Pre-reading guide
[I] Intermediate transport roller
(1) Take off the front cover.
( P. 4-1 "[A] Front cover")
(2) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(3) Take off the jam access cover.
( P. 4-2 "[C] Jam access cover")
(4) Take off the left cover.
( P. 4-3 "[D] Left cover")
(5) Remove 1 screw and take off the hinge pin.
Fig. 4-34
(6) Disconnect 1 connector. Remove 2 screws
and take off the pre-reading guide.
Fig. 4-35
(1) Take off the pre-reading guide.
( P. 4-12 "[H] Pre-reading guide")
(2) Take off the read motor drive section.
( P. 4-18 "[C] Read motor (M2)")
(3) Remove 1 bushing, 1 screw, 1 pulley and 1
bushing from the rear side of the intermedi-
ate transport roller shaft.
(4) Remove 1 bushing from the front side of the
intermediate transport roller shaft.
(5) Take off the intermediate transport roller.
Fig. 4-36
Hinge pin
Pre-reading guide
Bushing
Bushing
Intermediate transport roller
Bushing
Pulley
Screw
07/06