Filter
Top Products
User’s Manual 6-15
Power and Power-Up Modes
1. Save your work.
2. Turn the computer’s power off. Make sure the Power indicator is off.
3. Remove all cables connected to the computer.
4. Close the LCD display panel and turn the computer upside down.
5. Slide the battery lock (➀) to the unlock position ( ). (Move it
completely to the left).
6. Slide and hold the battery release latch (➁) to disengage the battery
pack, then remove the battery pack (➂).
Figure 6-1 Releasing the battery pack
■ Do not remove the battery pack while the computer is in Standby
Mode. Data is stored in RAM, so if the computer loses power it will be
lost.
■ In Hibernation Mode, data will be lost if you remove the battery pack or
disconnect the AC adaptor before the save is completed. Wait for the
HDD indicator to go out.
■ Do not touch the battery release latch while holding the computer or the
battery pack might fall out due to the unintentional release of the
battery release latch and cause injuries.
Battery pack
Battery
release latch
Battery lock
➂
➁
➀