Filter
Top Products
H5R & H5E AV500 Hybrid Wi-Fi Starter Kit
- 9 -
Chapter 2. Hardware Connection
2.1 System Requirements
¾ Broadband Internet access service (DSL/Cable/Ethernet)
¾ One DSL/cable modem that has an RJ45 connector (which is not necessary if the router is
connected directly to the Ethernet)
¾ PCs with a working Ethernet adapter and an Ethernet cable with RJ45 connectors
¾ TCP/IP protocol on each PC
¾ Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari
2.2 Installation Environment Requirements
¾ Place the router in a well ventilated place far from any heater or heating vent
¾ Avoid direct irradiation of any strong light (such as sunlight)
¾ Keep at least 2 inches (5 cm) of clear space around the router
¾ Operating Temperature: 0℃~40℃ (32℉~104℉)
¾ Operating Humidity: 10%~90%RH, Non-condensing
2.3 Connecting Hardware
Before connecting the router and extender, make sure your PC is connected to the Internet
through the broadband service successfully. If there is any problem, please contact your ISP. After
that, please connect the router and extender according to the following steps. Don't forget to pull
out the power plug and keep your hands dry.
1. Connect the WAN port of the router to the Internet with an Ethernet cable.
2. Connect a LAN port of the router to your computer with another Ethernet cable.
3. Connect the power socket of the router to a wall socket with the supplied power adapter.
4. Plug the extender into a nearby wall socket.
5. Turn on the ON/OFF switch to power on the router and wait for 1 minute.
)
Note:
1) The router and extender must be plugged into wall sockets under the same electric meter.
2) Configure the router before performing AP clone.