Filter
Top Products
153
not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 260.
leave-time —— Leave Time, which is the interval between the switch receiving
a leave message from a host and the switch removing the host from the
multicast groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1.
port —— The Ethernet port number.
Command Mode
Global Configuration Mode
Example
Enable Multicast VLAN 3, and configure Router Port Time as 100 seconds,
Member Port Time 100 seconds, Leave Time 3 seconds, and Static Router Port
port 3:
T1500-28PCT(config)# ip igmp snooping multi-vlan-config 3 rtime 100
T1500-28PCT(config)# ip igmp snooping multi-vlan-config 3 mtime 100
T1500-28PCT(config)# ip igmp snooping multi-vlan-config 3 ltime 3
T1500-28PCT(config)# ip igmp snooping multi-vlan-config 3 rport interface
fastEthernet 1/0/3
ip igmp snooping filter add-id
Description
The ip igmp snooping filter add-id command is used to configure the
multicast IP-range desired to filter. To delete the corresponding IP-range, please
use no ip igmp snooping filter add-id command. When IGMP Snooping is
enabled, you can specified the multicast IP-range the ports can join so as to
restrict users ordering multicast programs via configuring multicast filter rules.
Multicast IP addresses ranges from 224.0.0.0 to 239.255.255.255. The range
for receivers to join is from 224.0.1.0 to 239.255.255.255.
Syntax
ip igmp snooping filter addr-id addr-id list
no ip igmp snooping filter addr-id addr-id list
Parameter
addr-id list —— The filtering address ID to be bound.