76
count (-i) —— The interval to send ICMP request packets. It ranges from 100 to
1000 milliseconds. By default, this value is 1000.
Command Mode
User EXEC Mode and Privileged EXEC Mode
Example
To test the connectivity between the switch and the network device with the IP
192.168.0.131, please specify the count (-l) as 512 bytes and count (-i) as 1000
milliseconds. If there is not any response after 8 times’ Ping test, the connection
between the switch and the network device is failed to establish:
T1500-28PCT# ping 192.168.0.131 –n 8 –l 512
tracert
Description
The tracert command is used to test the connectivity of the gateways during its
journey from the source to destination of the test data.
Syntax
tracert {ip-addr} [maxHops]
Parameter
ip-addr —— The IP address of the destination device.
maxHops —— The maximum number of the route hops the test data can pass
though. It ranges from 1 to 30. By default, this value is 4.
Command Mode
User EXEC Mode and Privileged EXEC Mode
Example
Test the connectivity between the switch and the network device with the IP
192.168.0.131. If the destination device has not been found after 20 maxHops,
the connection between the switch and the destination device is failed to
establish:
T1500-28PCT# tracert 192.168.0.131 20