87
no storm-control broadcast
Parameter
rate —— Specify the bandwidth for receiving broadcast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. By default, the value is
“128K”.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the broadcast control function for port 5:
T1500-28PCT(config)# interface fastEthernet 1/0/5
T1500-28PCT(config-if)# storm-control broadcast
storm-control multicast
Description
The storm-control multicast command is used to enable the multicast control
function. To disable the multicast control function, please use no storm-control
multicast command. Multicast control function allows the switch to filter
multicast in the network. If the transmission rate of the multicast packets
exceeds the set bandwidth, the packets will be automatically discarded to avoid
network broadcast storm.
Syntax
storm-control multicast [rate rate]
no storm-control multicast
Parameter
rate —— Select the bandwidth for receiving multicast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. By default, the value is
“128K”.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the multicast control function for port 5:
T1500-28PCT(config)# interface fastEthernet 1/0/5