Filter
Top Products
186
Status will be changed to Tx&Rx. To disable the LLDP-MED feature for the
corresponding port, please use no lldp med-status command.
Syntax
lldp med-status
no lldp med-status
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the LLDP-MED feature for port 1/0/2:
T1500-28PCT(config)# interface fastEthernet 1/0/2
T1500-28PCT(config-if)# lldp med-status
lldp med-tlv-select
Description
The lldp med-tlv-select command is used to configure LLDP-MED TLVs to be
included in outgoing LLDPDU for the corresponding port. To exclude
LLDP-MED TLVs, please use no lldp med-tlv -se lect command. By default, All
TLVs are included in outgoing LLDPDU.
Syntax
lldp med-tlv-select { [inventory-management] [location] [network-policy]
[power-management] [all] }
no lldp med-tlv-select { [inventory-management] [location] [network-policy]
[power-management] [all] }
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Exclude “network policy” and “inventory” TLVs in LLDPDU outgoing from port
1/0/2:
T1500-28PCT(config)# interface fastEthernet 1/0/2
T1500-28PCT(config-if)# no lldp med-tlv-select network-policy
inventory-management