Filter
Top Products
Chapter 2 Using the Hardware
9
Mounting the RS700
The RS700 comes standard with a wall mounting kit for easy installation.
Mount the RS700 to a wall through the following:
• Plastic conical anchor (4) 3x25mm.
• Self-tapping screw (4) 3.5x19mm.
1. Locate the four mounting holes on the RS700.
2. Place the RS700 on the wall. Mark the mounting hole locations with a pen.
3. Remove the RS700 and drill four 1/4-inch wide holes at least one inch deep.
4. Insert the four plastic conical anchors into the holes.
5. Secure the RS700 to the wall with the four self-tapping screws, and insert them
into the plastic conical anchors.
Mounting
Holes
Mounting
Holes