Filter
Top Products
35
Chapter 4
Advanced Settings
The RS700 provides a standard interface to setup the terminal, and It is possible
through this to make connections and perform remote control functions.
Connecting to a LAN Network
Obtaining an IP Address
Connect to a network through the following:
1. Connect the computer to a DHCP enabled network.
2. Connect the Ethernet cable to the Ethernet Port on the RS700’s bottom panel,
and rotate the cable cap clockwise to secure the connection.
3. Connect the RS700 to the same network via DHCP. The DHCP server will
assign an IP address to the RS700.
4. On the computer, click Start → Programs → Smart-Reader Server Remote
Control → Reader Discovery.
5. Click Discovery to lookup the DHCP client in the same subnet.