Filter
Top Products
ii
Regulatory Compliance Statements
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B dig-
ital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following
measures:
• Relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit that is different from the con-
nected receiver.
• Consult the dealer or an experienced radio/television technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
This device and its antenna(s) must not be cohabited or operate in conjunction with
any other antenna(s) or transmitter(s).
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncon-
trolled environment. End users must follow the specific operating instructions for satis-
fying RF exposure compliance. Please follow the operation instructions in this manual
to main compliant with FCC RF exposure compliance requirements. This fixed RFID
Terminal meets FCC RF exposure guidelines when used in fixed RFID operation.
RoHS Statement
This device conforms to RoHS (Reduction Of Hazardous Sub-
stances) European Union regulations that set maximum concen-
tration limits on hazardous materials used in electrical and
electronic equipment.