Filter
Top Products
2-10 Basic Installation
Final Steps
Save your configuration and reboot the NETServer. Note that
the LAN port settings are the only configuration changes that
will require rebooting the NETServer.
To save your changes, type the following:
save all
Enter
Wait until the RN/FL LED is green. Rebooting the NETServer
while a save is in progress could cause the flash memory to be
corrupted. When the LED is green, type the following:
reboot
Enter
Note that the NETServer may respond with a command prompt
to indicate that it has received the reboot command, but you will
not be able to access the NETServer until it finishes rebooting.
When the NETServer finishes rebooting, the login prompt will
reappear.
From this point on, configuration can also be done from the
Windows-based NETServer Manager software. If you would
rather configure the NETServer from Windows, proceed to the
Installation and Recommended Configuration sections of the
NETServer Windows Software Guide.