Filter
Top Products
6-24 LAN-to-LAN Routing
Routing
Set the level of RIP messaging that the two devices will ex-
change during the connection. Use the following command:
set user <user name> routing <
broadcast
|
listen
|
on
|
off
>
broadcast Send dynamic routing information to the remote
device. (but do not listen)
listen Listen for dynamic routes received from the remote
device. (but do not broadcast)
on Do both of the above.
off Do not send dynamic routing information. Ignore
dynamic routes received.
Compression
Van Jacobson TCP/IP header compression should be enabled for
a SLIP connection only if both the local NETServer and the
remote device are configured to use compressed SLIP (CSLIP).
Both sides must agree on whether to use compression or the
connection will fail.
Enabling compression on a PPP connection will cause the
NETServer to negotiate for compression. Compression will be
used only if the remote device supports it. Use the following
command:
set netuser <user name> compression <
on
|
off
>
Step 3 - Save your changes
Use the following command:
save user <user name>