Filter
Top Products
FUNCTION SELECTION VIA LINE (FSL) COMMANDS
X2—Restore Settings from Permanent Storage
@X2
Restores nonvolatile memory (NVM) to random access memory
(RAM). The printer will be updated with the escape strings,
according to these settings. This command saves all current
settings in NVM including the interface escape character.
X3—Restore Factory Default Settings
@X3
Restores factory default settings in Random Access Memory
(RAM).
Function X3 overwrites the contents of RAM that results in a loss
of settings contained in RAM. This function only affects the used
port, and reads factory default into temporary memory. This
function causes the saved software setup commands to be
overwritten by the factory default commands, effectively resetting
the RAM.
X4—Restore Settings from Permanent Storage
@X4
Restores NVM to RAM, and reads permanent memory into
temporary memory. This function causes any unsaved settings to
be overwritten by the currently saved commands. The printer is
updated with the escape strings according to these settings.
(@X2 equivalent @X4.)
Y1—Set IBM Buffer Size
@Y1, n@
Changes default buffer size. It selects the buffer size the printer
uses to print the contents of a terminal screen in DSC mode.
This type of operation is usually done when you want to copy
the contents of a terminal screen, or the host computer sends
data to the printer and the terminal at the same time. This
function also affects the buffer size if it is done in the SCS
mode. The factory default setting is 3440.
n Valid parameters are:
1 for 960 characters
2 for 1920 characters
3 for 2560 characters
4* for 3440 characters
5 for 3564 characters.
Remember This function should not be set during normal operation. Once
programmed, the new value should be stored with the X1
function. Be sure to switch the printer off for 10 seconds before
you switch it on again.
3-12 XEROX MRP FAMILY COAX COMMAND REFERENCE