Filter
Top Products
FUNCTION SELECTION VIA LINE (FSL) COMMANDS
Y48—Set Permanent Escape
@Y48, ’n1’@ or @Y48,<xx>@
Selects the permanent escape character.
n1 or
<xx>
Character for permanent escape character
selected from the LU3 character table
xx = 0* No escape character
Example 1 @Y48, ‘>’@ sets the character > as permanent escape
character. Subsequent FSL escape strings will then require > as
escape character.
Example 2 @Y48, ‘ ’@, @Y48, 00@ clears the permanent escape character.
No permanent escape character is used.
Y49—Restrict Access of Temporary and Permanent Settings
@Y49, n1 ‘password’@
Locks the settings stored in the temporary and permanent
memory areas by disabling Function Selection via Line (FSL).
n Values for n are:
0* Unlock FSL functions.
1 Lock the settings in temporary and
permanent memory areas.
2 Lock the settings in permanent memory
only.
When n =1 is selected, use n = 0 to enable FSL again. Refer to
examples 1 and 2. Various levels (0, 1, and 2) are available,
depending on your needs.
Note This FSL must be used with the Y249 and Y253 functions. Y249
is needed to enter engineering mode, and Y253 is needed to
allow passwords.
Example 1 @Y249, FOREST@
@Y253, 1@
@Y49, 1, JET@ locks both the temporary and permanent
memory areas with the password “JET” (if it has been installed).
Example 2 @Y249, FOREST@
@Y253, 1@
@Y49, 0, JET@ unlocks the memory areas again.
3-40 XEROX MRP FAMILY COAX COMMAND REFERENCE