Filter
Top Products
Page 11-16 Xerox CopyCentre C20, WorkCentre M20 and WorkCentre M20i User Guide
Troubleshooting
Half of the page is blank The page layout is too
complex.
Reduce the resolution setting from 600 dpi to
300 dpi. Install more RAM in the computer.
The page orientation may
be incorrect.
Change the page orientation in the printer setup
dialog.
Printing is too slow The computer parallel
port may not be set for
high speed
communications.
If the computer is equipped with an ECP parallel
port, enable this mode of operation. Refer to the
Enabling High Speed Printer Communications
section of the PC’s user guide.
If using Windows 95, the
spool setting may be set
incorrectly.
Point to the Start Task bar and then click
Settings, then Printers. Click the product icon
with the right mouse button. Click Properties
and then spool settings on the Details tab. Enter
the required setting from the available choices.
Computer may not have
enough memory (RAM).
Install more RAM in the computer.
Print job is too large Reduce resolution from 600 dpi to 300 dpi.
Irregular faded patches
of print
There is a paper quality
problem.
Use only paper that meets the specifications
required by the product.
Toner may be unevenly
distributed.
Remove the toner cartridge and shake it gently
to distribute the toner evenly. Then reinstall the
toner cartridge.
Black staining There is a paper quality
problem.
Use only paper that meets the specifications
required by the product.
Character voids The paper may be too
dry.
Try printing with a different batch of paper.
Background scatter The paper may be too
damp.
Try printing with a different batch of paper. Do
not open packages of paper until necessary so
that the paper does not absorb too much
moisture from the air.
Printing over uneven
surfaces.
If printing onto envelopes, change the printing
layout to avoid printing over areas that have
overlapping seams on the reverse side.
PROBLEM PROBABLE CAUSE SUGGESTED SOLUTION