Filter
Top Products
Running the Applications
XAPP979 (v1.0) February 26, 2007 www.xilinx.com 17
R
Select dynamic_eeprom and right click to build the project. If more than one software project
is used, make the unused software projects inactive.
Connect a serial cable to the RS232C port on the ML403 board. Start up a HyperTerminal. Set
Bits per second to 9600, Data bits to 8, Parity to None, and Flow Control to None, as shown in
Figure 20.
From XPS, start XMD and enter rst. Invoke GDB and select Run to start the application as
shown in Figure 21. The eeprom.c code written for the ML403 shown in the figure runs without
any modifications on this reference system.
Figure 20: HyperTerminal Parameters
Figure 21: Running dynamic_eeprom in GDB
X979_20_012907
X979_21_012907