Filter
Top Products
Page 14
2. Installing the MULTI-WAN GATEWAY in your LAN
Figure 2-4: Installation Diagram
1. Ensure that the MULTI-WAN GATEWAY and any DSL/Cable modem(s) are powered-OFF.
Leave the modem or modems connected to their data lines.
2. Connect the Broadband modem(s) to the MULTI-WAN GATEWAY.
• If using only one (1) Broadband modem, connect it to port 1.
• Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a standard
cable.
3. Use standard LAN cables to connect PCs to the LAN ports on the MULTI-WAN GATEWAY.
• Both 10BaseT and 100BaseT connections can be used simultaneously.
• If you need to connect the MULTI-WAN GATEWAY to another Hub, just use a standard LAN
cable to connect any LAN port on the MULTI-WAN GATEWAY to a standard port on another
hub. Any LAN port on the MULTI-WAN GATEWAY will automatically act as an "Uplink" port
when required.
• If devices are connected to the 2 WAN ports (1 and 2), the remaining ports (3 to 16), are LAN
ports.
4. Power-Up
• Power-on the Cable or DSL modem(s).
• Connect the supplied power cord to the MULTI-WAN GATEWAY and power-up.
5. Check the LEDs
• The Power LED should be ON.