Filter
Top Products
Page 32
Configuring Other Routers on your LAN
All traffic for devices not on the local LAN must be forwarded to the MULTI-WAN GATEWAY so that it
can be forwarded to the Internet. This is done by configuring other Routers to use the MULTI-WAN
GATEWAY as the Default Route or Default Gateway, as illustrated by the example below.
Static Routing - Example
Router B
(192.168.2.90)
(192.168.3.70)
Router A
Segment 0
Segment 2
Segment
1
(192.168.1.xx)
(192.168.2.xx)
(192.168.1.100)
(192.168.1.1)
(192.168.3.xx)
(192.168.2.80)
Figure 4-3: Routing Example
For the MULTI-WAN GATEWAY Gateway's Routing Table
For the LAN shown above, with 2 routers and 3 LAN segments - the MULTI-WAN GATEWAY requires
2 entries as follows:
Entry 1 (Segment 1)
Destination IP
Address
192.168.2.0
Network Mask 255.255.255.0
Gateway IP Address 192.168.1.100
Interface LAN
Metric 2
Entry 2 (Segment 2)
Destination IP 192.168.3.0