Filter
Top Products
Page 15
• The Link/ACT LED should be ON if the corresponding WAN port is connected to a
broadband modem.
• For each PC connected to the LAN ports, the corresponding LAN LED (either 10/Yellow or
100/Green) should be ON.
3. Configuring the MULTI-WAN GATEWAY for Internet Access
To configure access to the Internet, first decide how many WAN ports you are going to use. The
pull down menu on the MAX WAN web page (Figure 2-5) will let you setup the WAN port numbers.
You can choose from two (2), up to eight (8) WAN ports. Once you have selected how many ports
you are going to use, click on Submit. You may then proceed to the Primary Setup page.
Figure 2-5: MAX WAN
Select Primary Setup from the menu. You will see a screen like in the example below.
• Configure each WAN one by one through the Interface column pull-down menu.
• For any of the following situations, refer to Chapter 3: Advanced Port Setup, for any further
configuration which may be required:
• Using multiple WAN ports
• Enabling multiple IP addresses on each WAN port
• Enabling multiple PPPoE sessions
• PPTP connection method