Filter
Top Products
When the Indicators Provide No Help
42
Condition
Images appear dark
Probable cause Remedy
Is the lamp due for replacement?
If the LAMP/COVER indicator is flashing orange, it
means that the lamp will soon be due for replacement.
When the lamp is nearly due for replacement, the
image will become darker and the tint will become
poorer.
Replace the lamp with a new one. (p.48, 49)
Condition
Images appear green
Probable cause Remedy
Do the settings for component video input
signals match the signals from the connected
device?
If the “Component” or “RGB” settings are incorrect,
the images may appear greenish.
Use the “INPUT A Signal” or “INPUT B Signal”
commands in the “Signal” menu to select the signal
format that matches the connected source.
“Signal” - “INPUT A Signal” , “INPUT B Signal”
(p.30)
Condition
The remote control does not work
Probable cause Remedy
Is the remote control being pointed at the
right angle?
The operating angle for the remote control is
approximately 30
°
horizontally and approximately 30
°
vertically. Use the remote control within these ranges.
(
Setup Guide
)
Is the remote control too far from the
projector?
The operating distance for the remote control is
approximately 7 m (23 ft.). Use the remote control
within this distance. (
Setup Guide
)
Is direct sunlight or strong light from
fluorescent lamps shining onto the remote
control light-receiving area?
Avoid using projector in places where the remote
control light-receiving area is exposed to strong light.
Are there batteries in the remote control?
Insert batteries into the remote control. (
Setup Guide
)
Are the batteries dead?
Replace the batteries with new ones. (
Setup Guide
)
Have the batteries been inserted correctly?
Insert the batteries so that they face in the correct
direction. (
Setup Guide
)