Filter
Top Products
10 Zebra S400 & S600 User’s Guide
4. Adjust the media supply guide and the media guide against the outer
edge of the media. These guides must not cause pressure or excessive
drag on the media.
5. Close the head open lever, and see “Adjusting the Media Sensor” on
page 18 to adjust the media sensor position.
For loading fanfold media:
6. Refer to Figure 8. Make sure the fanfold media feeds through either
the bottom (f) or rear (g) access slot.
NOTE: When utilizing the bottom access slot, be sure to thread
media over the media supply hanger.
7. Thread the media through the printhead as shown in Figure 8.
8. Adjust the media supply guide and the media guide against the outer
edge of the media. These guides must not cause pressure or excessive
drag on the media.
9. Close the head open lever, and see “Adjusting the Media Sensor” on
page 18 to adjust the media sensor position.
Figure 8. Loading — Fanfold Media