Filter
Top Products
24 Zebra S400 & S600 User’s Guide
The other end of the parallel interface cable connects to the printer
connector at the host computer.
For pinout information, see “Parallel Interface Technical Information” on
page 69.
6HULDODQG3DUDOOHO&DEOLQJ5HTXLUHPHQWV
Data cables must be fully shielded and fitted with metal or metallized
connector shells. Shielded cables and connectors are required to prevent
radiation and reception of electrical noise.
To minimize electrical noise pickup in the cable:
1. Keep data cables as short as possible.
2. Do not bundle the data cables tightly with power cords.
3. Do not tie the data cables to power wire conduits.
&RPPXQLFDWLQJZLWKWKH3ULQWHU
9LDWKH3DUDOOHO3RUW
• Set the parallel connection on the host computer. For instructions, refer
to your computer’s user’s guide.
9LDWKH6HULDO3RUW
• Set the host computer to the factory defaults of the printer: 9600 baud, 8
bit word length, no parity, 1 stop bit, and XON/XOFF. For instructions,
refer to your computer’s user’s guide.
NOTE: If you can’t reset the host computer communications
settings, then you must establish a temporary parallel connection to
send down the Set Communications (^SC) command that changes
the printer’s settings to match the host settings.