Filter
Top Products
14 Zebra S400 & S600 User’s Guide
&XWWHU0RGH
(Cutter mode is optional).
To ensure proper media loading, follow the directions for the Tear-Off
mode with the exception that the end of the media must be positioned on
top of the platen roller. See Figure 10.
With the end of the media positioned directly on top of the platen roller (a),
close the head open lever. The printer automatically calibrates, feeds out,
and cuts the label when the printer is powered on or the printhead is
opened and closed.
NOTE: The cutter only cuts if the printer is in cutter mode. Refer
to the ZPL II Programming Guide or the label preparation software
user’s guide for instructions.
NOTE: The cutter cycles once at power up or resets (even when
NOT in cutter mode).
Figure 10. Loading — Cutter Mode