Zebra Technologies ZT220 Label Maker User Manual


 
35
Introduction
ZT230 Printer Control Panel Display
8/22/12 P1048261-004
SENSORS Menu (continued)
Items in this menu are shown in the order in which they appear when you press the RIGHT
ARROW. For more information about these settings, see Table 11, Sensor Settings
on page 95.
Set the Intensity of the Take Label LED
Important • This value is set during sensor calibration. Do
not change this setting unless you are told to do so by
Zebra Technical Support or by an authorized service
technician.
See Take Label on page 95 for more information.
Ports Menu Shortcut
To be taken to the next user menu, press OK or press RIGHT
SELECT to select
GO.
To continue to navigate in the same user menu, press the LEFT
ARROW or RIGHT ARROW.
TAKE LABEL
000
PORTS MENU
GO
GO
BAUD RATE
9600
TAKE LABEL
000
SENSOR TYPE
TRANSMISSIVE
GO