Filter
Top Products
Printer Configuration and Adjustment
Changing Printer Settings
80
P1048261-004 8/22/12
Print Method Specify if the printer is to use Direct Thermal mode (no ribbon) or Thermal Transfer mode
(using thermal transfer media and ribbon).
Accepted values:
• THERMAL TRANS
• DIRECT THERMAL
Related ZPL command(s):
^MT
SGD command used:
ezpl.print_method
Control panel menu item: PRINT METHOD on page 20
Printer web page:
View and Modify Printer Settings > Media Setup > Print
Method
Tear-Off
Position
If necessary, adjust the position of the media over the tear-off bar after printing.
• Higher numbers move the media out (the tear line moves closer to the leading edge of
the next label).
• Lower numbers move the media in (the tear line moves closer to the edge of the label
just printed).
Accepted values:
–120 to 120
Related ZPL command(s):
~TA
SGD command used:
ezpl.tear_off
Control panel menu item: TEAR OFF on page 21
Printer web page:
View and Modify Printer Settings > General Setup >
Tear Off
Table 7 • Print Settings (Continued)
1
2
1
Media direction
2
Factory-set tear line location at position 000