Filter
Top Products
Chapter 19 Firewall
ZyWALL 110/310/1100 Series User’s Guide
275
19.3.1 The Session Limit Add/Edit Screen
Click Configuration > Firewall > Session Limit and the Add or Edit icon to display the Firewall
Session Limit Edit screen. Use this screen to configure rules that define a session limit for specific
users or addresses.
Figure 166 Configuration > Firewall > Session Limit > Edit
The following table describes the labels in this screen.
User This is the user name or user group name to which this session limit rule applies.
IPv4 Address This is the IPv4 address object to which this session limit rule applies.
IPv6 Address This is the IPv6 address object to which this session limit rule applies.
Description This is the information configured to help you identify the rule.
Limit This is how many concurrent sessions this user or address is allowed to have.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
Table 100 Configuration > Firewall > Session Limit (continued)
LABEL DESCRIPTION
Table 101 Configuration > Firewall > Session Limit > Edit
LABEL DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this screen.
Enable Rule Select this check box to turn on this session limit rule.
Description Enter information to help you identify this rule. Use up to 60 printable ASCII characters.
Spaces are allowed.
User Select a user name or user group to which to apply the rule. The rule is activated only
when the specified user logs into the system and the rule will be disabled when the user
logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of any in the field below, the
user’s IP address should be within the IP address range.
Address Select the IPv4 source address or address group to which this rule applies. Select any to
apply the rule to all IPv4 source addresses.
IPv6 Address Select the IPv6 source address or address group to which this rule applies. Select any to
apply the rule to all IPv6 source addresses.