Filter
Top Products
Chapter 2 Hardware Installation
Hardware Installation
2-23
and the ribbed side facing down. Press the release tab and adjust the
position of the cable clamp along the strap.
Figure 2-23: Inserting Cable Strap into Cable Clamp
Step 3. Mount the cable strap to the chassis by inserting the push-in barb
anchor into the pre-drilled hole underneath the power supply.
Step 4. Secure the power cord with the cable clamp Flip open the cable
clamp and wrap it around the power plug. If necessary, press on the
release tab to adjust the location of the clamp so it aligns with the base
of the power plug as shown below. Press the clip lock on the side of
the clamp until it snaps into position.
Figure 2-24: Power Cord Locked into Position
Step 5. Repeat the process to secure every power cords to the subsystem.