Filter
Top Products
3.11 public-key-code end
Syntax
public-key-code end
View
Public key view
Parameter
None
Description
Using the public-key-code end command, you can end the public key editing and
save the configured public key. Besides, you can also use this command to return
from the public key view to the system view.
After ending the public key editing by executing this command, the system will verify
the validity of the key before saving the key. If there is any invalid character in the
character string, the system will prompt that it will discard all the public key data
configured by the user due to the presence of invalid characters and will return to the
public key view from the current view . In this case, you can access the public key
edit view again using the public-key-code begin command and input new public key
data using the hex command. If you do not want to input the key data again, you can
exit to the system view by executing the public-key-code end command.
If the system makes sure that the configured key is valid, it will save the public key
into the link table of public keys and exit the current view to the system view.
In public key edit view, you are unable to exit to the system view by executing the
command quit or return.
For related commands, see rsa peer-public-key, public-key-code begin, and hex.
Example
Input an invalid character string when configuring a public key.
[3Com] rsa peer-public-key mykey
[3Com-rsa-public-key] public-key-code begin
[3Com-rsa-key-code] public-key-code end
% Invalid key string, the length is zero.
Input a valid character string when configuring a public key.
[3Com] rsa peer-public-key mykey
3Com Router Command Reference Guide Addendum for V1.2
58