Filter
Top Products
undo ntp-service unicast-peer X.X.X.X
View
System view
Parameter
X.X.X.X: IP address of the remote server.
version: Defines NTP version number.
number: NTP version number in the range of 1 to 3.
authentication-keyid: Defines an authentication key.
keyid: The key ID carried in the messages transmitted to the remote server, which is
in the range of 1 to 4294967295.
source-interface: Specifies interface name.
interface-name: Interface name. The IP address of the interface will be used as the
source IP address of the NTP messages that the local device sends to its peer.
interface-type: Interface type, which identifies an interface along with
interface-number.
interface-number: Interface number, which identifies an interface along with
interface-type.
priority: Specifies the server to be the preferred server.
Description
Using the ntp-service unicast-peer command, you can enable the NTP unicast peer
mode. Using the undo ntp-service unicast-peer command, you can disable the NTP
unicast peer mode.
By default, version number is 3, authentication is disabled, and the server is not the
preferred choice.
This command sets the remote server at X.X.X.X to be the peer of the local device
running in symmetric active mode. X.X.X.X represents a host address, which must
not be a broadcast or multicast address, or the IP address of the reference clock.
With all these configurations, the local device can synchronize its clock to the remote
server and vice versa.
3Com Router Command Reference Guide Addendum for V1.2
81