Filter
Top Products
Unit Overview — Rear 1-9
Power Socket
The Switch 3000 TX automatically adjusts to the
supply voltage. The fuse is suitable for both 110V
A.C. and 220–240V A.C. operation. For informa-
tion on replacing fuses, refer to Appendix A
.
Unit Serial Number
You may need this serial number for fault reporting
purposes.
Redundant Power System Socket
Use one of these sockets to connect a SuperStack II
Redundant Power System (RPS) to the unit. You can
use either socket. Refer to “
Connecting a Redun-
dant Power System (RPS)” on page 2-6.
Reset Button
Press the reset button to simulate a power-off/on
cycle. This has the same effect as carrying out a
reset via the VT100 interface; refer to “
Resetting the
Switch 3000 TX” on page 4-26.
Console Port
Connect a terminal to the console port to carry out
remote or local out-of-band configuration and man-
agement. Configuration for the console port is set
to auto-baud, 8 data bits, no parity, and 1 stop bit.
Plug-in Module Slot
Use this slot to install a Plug-in Module. The Module
can be used to provide an additional high speed link
to the rest of your network. 3Com provides a range
of Plug-in Modules; contact your supplier for avail-
ability.
When no Plug-in Module is installed, the blanking
plate should be secured in place.
Ethernet Address
This label shows the unique Ethernet (or MAC)
address assigned to the unit.