Filter
Top Products
Port Statistics 6-3
Port Statistics
With the Switch Management screen displayed,
choose the management level
port
, then select the
STATISTICS button. The Port Statistics screen is dis-
played as shown in Figure 6-2
.
As well as showing statistics for the port, the Port
Statistics screen allows you access to traffic and
error counter screens.
If the port is an ATM OC-3c Module port, the ATM
Port Statistics screen is displayed. For more informa-
tion, refer to the “SuperStack
®
II Switch ATM
OC-3c Module User Guide”.
The Port Statistics screen shows the following:
Port ID
The ID of the port you are currently manag-
ing.
Bandwidth Used
This counter provides a running
average of the bandwidth used by the port,
expressed as a percentage of the maximum band-
width available for the port. A sampling period of
1 minute is used. The value gives an indication of
the general traffic level of the network. A high utili-
zation for single endstation segments is an indica-
tion that your network is operating efficiently.
However, if multiple endstations are connected to
this port and you see values of around 40% you
should reconsider the topology of your network
because each user will see degraded network per-
formance.
Figure 6-2
Port Statistics screen
Frames Forwarded
This counter provides a running
average of the proportion of the frames received by
the port that are forwarded, expressed as a percent-
age of all frames received by the port. A sampling
period of 1 minute is used.
Broadcast Frame Bandwidth
This counter provides
a running average of the broadcast frame band-
width used by the port, expressed as a percentage
of the maximum bandwidth available for the port. A
sampling period of 5 seconds is used.
Error Frames
This counter provides a running aver-
age of the number of errors per 10,000 frames
received and is expressed as a percentage. Refer to
the field description for Errors on page 6-5
.
TRAFFIC STATISTICS
Select this button to access
traffic counters for this port.
ERROR ANALYSIS
Select this button to access
error counters for this port.