Filter
Top Products
1-10 CHAPTER 1: SWITCH 3800 OVERVIEW
MAC Address
This label shows the unique Ethernet MAC address assigned to this
device.
Console Port
The console port (9-pin, “D” type connector) is used to connect a
terminal and to carry out local out-of-band management.
Factory Defaults Table 1-3 shows the factory defaults for the Switch 3800 features.
Table 1-3 Switch 3800 Factory Defaults
Item Default Setting
Port status Enabled on all ports
Default user account admin with no password and user with no
password
Console port configuration 9600 baud, eight data bits, one stop bit, no
parity, XON/XOFF flow control enabled
SNMP read community string Public
SNMP write community string Private
RMON history session Enabled
RMON alarms Enabled
■ Send trap if load is greater than 75% of
available bandwidth
■ Send trap if there are more than 10 errors in
1,000 packets
PACE Recognition disabled
Virtual LANs One VLAN named default; all ports belong to the
default VLAN; no protocol filter used.
802.1Q tagging All packets are untagged on the default VLAN
(default)
BOOTP Enabled on the default VLAN (default)
Spanning Tree Protocol Disabled; one defined as “s0”
IP Routing Disabled
Forwarding database aging
period
30 minutes
RIP Protocol Disabled
Autonegotiation On
SW3800.BK Page 10 Tuesday, May 5, 1998 5:20 PM