Filter
Top Products
Using Telnet 3-7
4 At the password prompt, enter the password and press [Return].
When you have successfully logged on to the Switch, the
command-line prompt displays the name of the Switch in its prompt.
5 Assign an IP address and subnetwork mask for the default VLAN by
using the following command
config vlan <name> ipaddress <ipaddress> {<subnet_mask>}
For example:
config vlan default ipaddress 123.45.67.8 255.255.255.0
Your changes take effect immediately.
6 Configure the default route for the Switch using the following
command:
config iproute add default <ipaddress> {<metric>}
For example:
config iproute add default 123.0.0.1 1
7 Save your configuration changes so that they will be in effect after the
next Switch reboot, by typing
save
For more information on saving configuration changes, refer to
Chapter 10.
8 When you have finished using the facility, log out of the Switch by
typing
logout
Disconnecting a
Telnet Session
For security purposes, an administrator access level account can
disconnect a management session that has been established by way of
a Telnet connection. If this happens, the user logged on by way of the
Telnet connection is notified that the session has been terminated.
To terminate a Telnet session, follow these steps:
1 Logon to the Switch with an administrator access level.
2 Determine the session number of the session you want to terminate by
typing
show session
SW3800.BK Page 7 Tuesday, May 5, 1998 5:20 PM