Switch 3800 Commands 4-13
PACE Commands Table 4-11 describes PACE commands.
config port <portlist> auto off {speed
[10 | 100]} duplex [half | full]
Allows you to change the configuration of a group of
10/100 Mbps ports. Specify the following:
■ auto off — The port will not autonegotiate the
settings.
■ speed — The speed of the port (for 10/100 Mbps
ports only).
■ duplex — The duplex setting (half- or full-duplex).
config port <portlist> auto off duplex
full
Allows you to disable autonegotiation on a Gigabit
port.
enable port <portlist> Allows you to enable one or more ports.
enable sharing <master_port> grouping
<portlist>
Allows you to define a load-sharing group of ports.
The ports specified in <portlist> are grouped to the
master port.
enable smartredundancy <portlist> Allows you to enable the SmartRedundancy feature on
the redundant Gigabit Ethernet port. When the
SmartRedundancy feature is enabled, the Switch
always uses the primary link when the primary link is
available. The default setting is enabled.
disable port <portlist> Allows you to disable one or more ports.
disable sharing <master_port> Allows you to disable a load-sharing group of ports.
disable smartredundancy <portlist> Allows you to disable the SmartRedundancy feature. If
the feature is disabled, the Switch changes the main
link only when the current main link becomes
inoperable.
Table 4-10 Port Commands
Command Description
Table 4-11 PACE Commands
Command Description
enable pace Allows you to enable recognition of the PACE bit.
disable pace Allows you to disable recognition of the PACE bit.
SW3800.BK Page 13 Tuesday, May 5, 1998 5:20 PM