Switch 3800 Commands 4-15
config stpd <stpd_name> port cost <value>
<portlist>
Allows you to specify the path cost of the port in this
STPD.
The range is 1–65,535. The Switch automatically assigns
a default path cost of 1.
config stpd <stpd_name> port priority
<value> <portlist>
Allows you to specify the priority of the port in this
STPD. By changing the priority of the port, you can
make it more or less likely to become the Root Port.
The range is 0–255. The default setting is 128. A
setting of 0 indicates the lowest priority.
enable stpd [<stpd_name> | all] Allows you to enable STP for one or more STPDs. The
default setting is disabled.
disable stpd [<stpd_name> | all] Allows you to disable the STP mechanism on a
particular STPD, or for all STPDs.
enable stpd port <portlist> Allows you to enable the STP protocol on one or more
ports. If the STPD is enabled for a port, BPDUs will be
generated on that port if STP is enabled for the
associated STPD. The default setting is enabled.
disable stpd port <portlist> Allows you to disable STP on one or more ports.
Disabling STP on one or more ports puts those ports in
FORWARDING state; all BPDUs received on those ports
will be disregarded.
unconfig stpd {<stpd_name> | all} Allows you to restore default STP values to a particular
STPD or to all STPDs.
Table 4-12 STP Commands (continued)
Command Description
SW3800.BK Page 15 Tuesday, May 5, 1998 5:20 PM