Filter
Top Products
2
NETWORK INTERFACE CARD
INSTALLATION
This chapter describes how to install the 3C905C NIC in your
PC and connect it to an Ethernet or Fast Ethernet network.
CAUTION: Do NOT physically install the NIC in your PC until
you have run the preinstallation program, as described in
“Running the Preinstallation Program” later in this chapter.
Overview
Table 3 provides an overview of how to install the
3C905C NIC, depending on your PC configuration.
Table 3 Installation Overview
Installation Task Instructions
Installing the NIC in
a new PC
To install the 3C905C NIC in a new PC or in a PC that
never has had a NIC installed:
1 Run the NIC preinstallation program before installing
the NIC in the PC, as described in this chapter.
2 Install the NIC in the PC and connect it to the network,
as described in this chapter.
3 Install the NIC driver and software. See Chapter 3 or
Chapter 4 for instructions.
Installing multiple NICs To install multiple 3C905C NICs in a Windows 95/98 or
Windows NT 4.0 PC, follow the instructions in “Installing
Multiple NICs” in Chapter 3.
To install multiple 3C905C NICs in a NetWare server,
follow the instructions in “Multiple NICs” in Chapter 4.
Replacing an
installed NIC
To install the 3C905C NIC in a PC in which a NIC has
previously been installed:
1 Remove the drivers and the NIC before installing the
3C905C NIC in the PC. See “Removing NIC Software”
in Chapter 6 for instructions.
2 Install the 3C905C NIC in the PC, following the
instructions in “Installing the NIC in a new PC” earlier
in this table.
(continued)
book Page 17 Monday, March 15, 1999 1:31 PM