Filter
Top Products
74 APPENDIX B: DYNAMICAccess SOFTWARE INSTALLATION AND CONFIGURATION
Installing DynamicAccess Software
To install DynamicAccess software:
1 Make sure that the NIC and its software are installed
on your PC.
See “Verifying Successful Installation” in Chapter 3 to
confirm that the NIC is properly installed in the PC.
2 Start Windows.
3 Double-click the DAINST.EXE file on your hard drive.
This file is automatically copied to your hard drive during
the NIC driver installation into the following directory:
■ Windows 95/98 — C:\WINDOWS\SYSTEM
■ Windows NT 4.0 — C:\WINNT\SYSTEM32
■ Windows NT 3.51 — C:\WINNT35\SYSTEM32
If you cannot locate the file on your hard drive, copy the
file from EtherDisk diskette 2 to the appropriate directory.
The file is expanded and the DynamicAccess software is
installed on your PC.
4 Restart the PC.
You must restart the PC to complete the installation.
Table 12 DynamicAccess Software Minimum Client Requirements
Operating
System
PC Requirements
Recommended
Microsoft Service Pack
Windows 95 486/75 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
Windows 95 OSR2 or
Service Pack 1
Windows 98 486/75 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
None
Windows NT 4.0 Pentium/100 MHz CPU
32 MB RAM
5 MB available hard drive space
Service Pack 3
Windows NT 3.51 Pentium/100 MHz CPU
32 MB RAM
5 MB available hard drive space
Service Pack 5
book Page 74 Monday, March 15, 1999 1:31 PM