Filter
Top Products
B
DYNAMICAccess
SOFTWARE INSTALLATION
AND CONFIGURATION
This chapter explains how to install and configure
DynamicAccess software on a PC running Windows 95,
Windows 98, or Windows NT.
For an overview of DynamicAccess software, see
Chapter 1. For detailed information on using, configuring,
and troubleshooting DynamicAccess software, access the
DynamicAccess Software User Guide from the
3Com World Wide Web site:
http://www.3com.com/dynamicaccess
Client PC Requirements
DynamicAccess software can be installed on a PC
running Windows 95, Windows 98, Windows NT 4.0,
or Windows NT 3.51.
CAUTION: If you plan to install DynamicAccess software
on a multiprocessor PC running Windows NT 4.0,
Service Pack 4, you must first download and install the
appropriate Microsoft patch available at:
http://www.3com.com/dynamicaccess/hotfixes
Failure to install the patch will result in system failure.
Table 12 lists the minimum client requirements and
recommended Microsoft Service Packs (if any) for the
version of DynamicAccess software that is included with
the 3C905C NIC on EtherDisk diskette 2.
book Page 73 Monday, March 15, 1999 1:31 PM