Filter
Top Products
9-8 CHAPTER 9: STATUS MONITORING AND STATISTICS
■ Message — The message contains the log information with text
that is specific to the problem.
Local Logging The Switch maintains 1,000 messages in its internal log. You can
display a snapshot of the log at any given point in time by using the
following command:
show log {<priority>} {<subsystem>}
where the following is true:
■ priority — Filters the log to display messages with the selected
priority or higher (more critical). Priorities include critical, warning,
and informational. If not specified, informational priority messages
and higher are displayed.
■ subsystem — Filters the log to display messages associated with
the selected Switch subsystem. Subsystems include Syst, STP, Brdg,
SNMP, Telnet, VLAN, and Port. If not specified, all subsystems are
displayed.
Real-time Display
In addition to viewing a snapshot of the Switch log, you can configure
the Switch to maintain a running real-time display of log messages on
the console. To turn on the log display, use the following command:
enable log display
To configure the log display, use the following command:
config log display {<priority>} {<subsystem>}
Brdg Bridge-related functionality. Examples include low table
space and queue overflow.
SNMP SNMP information. Examples include community string
violations.
Telnet Information related to Telnet logon and configuration
performed by way of a Telnet session.
VLAN VLAN-related configuration information.
Port Port management-related configuration. Examples
include port statistics and errors.
Table 9-3 Fault Log Subsystems
Subsystem Description
SW9000.BK Page 8 Wednesday, April 1, 1998 11:00 AM