Filter
Top Products
Port Commands 4-13
PACE Commands Table 4-11 describes PACE commands.
STP Commands Table 4-12 describes STP commands.
enable port <portlist> Allows you to enable one or more ports.
disable port <portlist> Allows you to disable one or more ports.
Table 4-10 Port Commands
Command Description
Table 4-11 PACE Commands
Command Description
enable pace Allows you to enable recognition of the PACE bit.
disable pace Allows you to disable recognition of the PACE bit.
Table 4-12 STP Commands
Command Description
show stpd {<stpd_name> | all} Displays STP information for one or all STPDs on the
Switch.
show stpd <stpd_name> port <portlist> Displays port-specific STP information, including the
forwarding state of each port.
create stpd <stpd_name> Allows you to create an STPD. When created, an STPD
has the following default parameters:
■ Bridge priority — 32,768
■ Hello time — 2 seconds
■ Forward delay — 15 seconds
delete stpd <stpd_name> Allows you to remove an STPD. An STPD can only be
removed if all VLANs have been deleted from it.
config stpd <stpd_name> add vlan <name> Allows you to add a VLAN to the STPD.
config stpd <stpd_name> delete vlan
[<name> | all]
Allows you to remove one or all VLANs from an STPD.
If all is specified, the association between the STPD
and VLAN is removed, but both still exist.
config stpd <stpd_name> hellotime <value> Allows you to specify the time delay (in seconds)
between the transmission of BPDUs from this STPD
when it is the Root Bridge.
The range is 1 through 10. The default setting is 2
seconds.
(continued)
SW9000.BK Page 13 Wednesday, April 1, 1998 11:00 AM