Filter
Top Products
50
Chapter 7
Windows
Peer-to-Peer
This chapter describes operation in a Windows Peer-to-Peer
Networking environment
Software Requirements
Operating Systems
Windows 95, Windows NT 4.0, Windows NT 3.51, or Windows for Workgroups
LAN Protocols
For Windows 95 or NT, the following protocols are supported:
• TCP/IP
• NetBEUI
• Windows SMB (Server Message Block)
In Windows for Workgroups, the following protocols are supported:
• NetBEUI
• Windows SMB (Server Message Block)
The procedures for each situation are described in the following sections.
TCP/IP
The following steps must be carried out.
• Software Installation
• Device configuration
• Software configuration
Software Installation
Software installation must be carried out on every Windows 95 or Windows NT
workstation intended to use the Print Server’s printers.
1. Run the SETUP program in the Driver\ptp_95nt folder on the CD-ROM.
2. At the Select Components window, select the TCP/IP protocol.
3. Once TCP/IP is selected, the Select Components screen will present 2 options:
• Install Device Driver
• Install SETBOX Program
The Device Driver needs to be installed on all workstations. The SETBOX
program is only used to assign IP Addresses to the Print Server. If you are using
the BiAdmin management program, you do NOT need SETBOX at all.
Otherwise, SETBOX should be installed only on the system administrator’s PC.
4. Complete the installation as normal. Reboot your system when setup is complete.
5. The Setup program will do the following:
7