Filter
Top Products
Appendix A: Command Line Interface Access April 14, 2006
A-12 MM70xG2-UM-03
Step Action
1
(cont.)
• Sustain Cell Rate
Enter 6 then type the QoS Sustainable Cell Rate (SCR) value supplied by your service provider. Use
for CBR, VBR-rt, and VBR-nrt ATM QoS. SCR is the average rate at which ATM cells are
transferred, measured in cells per second. The SCR must be less than the PCR. The valid range is
1-5500 cells per second.
• Maximum burst size
Enter 7 then type the QoS Maximum Burst Size (MBS) value supplied by your service provider. Use
with VBR-rt and VBR-nrt QoS. MBS is the maximum number of cells that can be transmitted at the
peak cell rate. The MBS rate must be equal to or less than the PCR. The default MBS is 0.
• Encapsulation
Type 8 then select the encapsulation type as indicated by the service provider. The options are:
1—Llc Encapsulation (Logical Link Control) allows multiple protocols to be run over the session.
This is the default encapsulation.
2—Vcmux (Virtual Channel Multiplexer) encapsulation allows one protocol to be run over the
session.
• WAN DHCP Enable
Type 9 then select 1 to Disable or 2 to Enable DHCP client. Enabling DHCP client provides the
capability where this session will automatically received an IP address from the service provider via
a DHCP server. If you enable DHCP client, leave the next two fields, WAN IP address and WAN
Network Mask, blank. These fields will automatically receive values.
• WAN IP Address
Type 10 then enter the IP address provided by the service provider for this session unless you have
enabled WAN DHCP. The default IP address is 0.0.0.0.
• WAN Network Mask
Type 11 then enter the network mask provided by the service provider for this session unless you
have enabled WAN DHCP. The default WAN Network Mask is 0.0.0.0.
• RIP Accept Mode
Type 12 then select one of the following:
1—No RIP
2—RIP Version 1
3—RIP Version 2
4—RIP Version 1 & 2 (default)
• RIP Send Mode
Type 13 then select one of the following:
1—No RIP
2—RIP Version 1
3—RIP Version 2 (default)
4—RIP Version 1 & 2
2Enter 14 to Apply the new setting and to add the new RFC1483 routed session to your session list; or you
can enter 15 to Delete session.