Filter
Top Products
Chapter 7: Implementing a Point-to-Point LAN Extension April 14, 2006
7-8 MM70xG2-UM-03
Configure the Central-Office LAN
Step Action
1Select LAN on the menu bar, then select LAN Setup under LAN Options to access the LAN
Configuration page (Figure 7-11).
Figure 7-11. LAN Configuration—Configure CO LAN
2 In the LAN Protocol box, confirm that the protocol is set to Bridged.
See Appendix A: “Command Line Interface Access” on page A-1 for procedures on using this interface to
change the LAN protocol.
3 In the IP Address box, enter an available IP address on your subnet.
4 Click Apply.
Note: If the protocol is not set to bridged, it can be changed only through the command line
interface.
Note: Any device (such as a PC) connecting to the modem LAN interface loses its connection
when the modem LAN IP address is changed. After the IP address is changed, you need to
specify this new address in the Web browser to reconnect a device.