Filter
Top Products
April 14, 2006 Chapter 4: Configuring the WAN
MM70xG2-UM-03 4-9
Permanently Save Sessions
After you have set up all the WAN sessions, save these changes permanently, as described in “Saving Changes” on
page 5-12.
Step Action
1
(cont.)
• RIP Send
This session forwards RIP version 1 (Ver 1), RIP version 2 multicast (Ver2 (M-cast)), RIP version 2
broadcast (Ver2 (B-cast)), or all versions of RIP packets. Select the RIP version or versions the
modem will send on this session. The default is Ver2 (B-cast).
• RIP Accept
This session receives RIP version 1 (Ver 1) only, RIP version 2 (Ver 2) only, or both versions of RIP
packets. Select the RIP version or versions the modem will receive for this session. The default is
RIP Ver 1 and Ver 2.
• Authentication
Select the authentication protocol provided by your service provider for PPP sessions. The
authentication protocol type must match at the modem and the service provider. The options are:
– PAP—The modem sends authentication requests to the service provider and authentication occurs
only once during the life of the DSL link.
– CHAP—The service provider returns an authentication challenge to the modem during the
authentication (default setting).
– NONE—No authentication is required for the session.
• Login
Change the default login name (admin) for this PPP session to the Login name supplied by the
service provider. Minimum login name length is one character and the maximum is 32 characters.
• Password
Change the default login password (password) for this PPP session to the Login password supplied
by the service provider. Minimum password length is six characters and the maximum is 32
characters.
2 Click Create to add the new PPPoA or PPPoE session to your session list on the WAN Configuration
page.