Filter
Top Products
April 14, 2006 Appendix A: Command Line Interface Access
MM70xG2-UM-03 A-11
Set Up an RFC 1483 Routed Session
You selected Create RFC 1483 routed session from the WAN Session Management menu (see Figure A-7 on
page A-8) to display the following menu.
Figure A-9. RFC 1433 Routed Session
Step Action
1 Configure the following parameters, 1 through 13, for the routing session:
• Session Name
Enter 1 then type a unique, descriptive identifier for the session. This name can have a maximum of
32 characters.
• Virtual Path ID (VPI)
Enter 2 then type the value (from 0 to 4,095) provided by the service provider. The number identifies
the virtual path that transports ATM cells between the modem and the service provider. This value
must match the virtual path identification (VPI) value the service provider uses for this connection.
• Virtual Channel ID (VCI)
Enter 3 then type the value (from 32 to 65,535) provided by the service provider. The number
identifies the virtual channel for this session that transports ATM cells between the modem and the
service provider. This value must match the virtual channel identification (VCI) value the service
provider uses for this connection.
• QoS Class
Enter 4 then select the ATM Quality of Service indicated by your service provider. The options are:
1—CBR (constant bit rate)
2—VBR-rt (variable bit rate real-time)
3—VBR-nrt (variable bit rate non-real-time)
4—UBR (unspecified bit rate is the default setting)
• Peak Cell Rate
Enter 5 then type the QoS Peak Cell Rate (PCR) value supplied by your service provider. If you are
not provided a PCR value, use the default. PCR is the maximum rate at which data is transferred on
the line and measured in ATM cells per second. The valid range is 1-5500 cells per second for
MM701G2 and 1-11000 cells per second for MM702G2. The default PCR is 5500.