Filter
Top Products
April 14, 2006 Chapter 4: Configuring the WAN
MM70xG2-UM-03 4-7
Set Up a PPPoA or PPPoE Routed Session
Selecting either PPPoA routed or PPPoE routed from the WAN Configuration page displays the following page
(Figure 4-4). The PPPoA routed configuration page is shown below as an example. The configuration parameters
for PPPoE routed are identical.
Figure 4-4. PPPoA Routed Session
Step Action
1
(cont.)
• IP Address
Enter the IP address provided by the service provider for this session. Or if DHCP Client was
selected, the IP address will automatically be assigned by a DHCP server on the WAN side of the
network. The default IP address is 0.0.0.0.
• Subnet Mask
Enter the subnet mask provided by the service provider for this session or use the default subnet
mask for the session which is 255.0.0.0. Or if DHCP Client was selected, the subnet mask will
automatically be assigned by a DHCP server on the WAN side of the network.
• RIP Send
This session forwards RIP version 1 (Ver 1), RIP version 2 multicast (Ver2 (M-cast)), RIP version 2
broadcast (Ver2 (B-cast)), or all versions of RIP packets. Select the RIP version or versions the
modem will send on this session. The default is Ver2 (B-cast).
• RIP Accept
This session receives RIP version 1 (Ver 1) only, RIP version 2 (Ver 2) only, or both versions of RIP
packets. Select the RIP version or versions the modem will receive for this session. The default is
RIP Ver 1 and Ver 2.
2 Click Create to add the new RFC1483-Router session to your session list on the WAN Configuration
page.