Filter
Top Products
61200214L1-1 IQ Probe User Manual 47
Chapter 6. DTE Port Configuration
For example:
If N392=3 and N393=4, then if three errors occur within any four
events, the interface is determined inactive.
The status of the connection can be viewed in the Status menu
under DTE Port Signaling State. The status will return to active
once the threshold is no longer exceeded.
Management DLCI (MGMT DLCI)
To use local PVC management, enter the management data link
connection identifier (DLCI). The management DLCI is a special
DLCI used between the attached DTE device and the IQ Probe to
carry SNMP and TELNET packets to/from the IQ Probe on the
DTE port.
Guidelines for Configuring Management DLCI
If the attached router or FRAD is used to route SNMP/TELNET
frames to the IQ Probe, set the Management DLCI to a unique
value (between 16 and 1007) that identifies the virtual circuit
between the router/FRAD and the IQ Probe. The router/FRAD
must also be configured to route the IQ Probe IP address to this
DLCI. The IP address and subnet mask for the DTE port must
also be set in the System Configuration menu.
Management PVC Option (MGMT PVC OPT)
If this option is set to ENABLED, the management DLCI is
included in the Full Status response to the router. Enable this
option when the management DLCI is used to route manage-
ment traffic to the IQ Probe.
Signaling Responses (SIG RESPONSES)
This option determines when PVC signaling responses are sent
to the router.
Always On
If ENABLED, PVC signaling responses are sent to the router
regardless of the network signaling state. Enable this option
when the IQ Probe is used for dial backup.